Tanache offers free worldwide Delivery from 2500 AED of Purchase.      For Free Trial at Your Home Use Coupon Code trytanache@home 

Rules & Ideas on how to wear a Ring

Rules & Ideas on how to wear a Ring

SOUNDS SIMPLE BUT HAVE YOU ACTUALLY WONDERED HOW TO WEAR YOUR RING PROPERLY ... HERE ARE FEW RULES AND IDEAS ON HOW TO DO IT

1. Make use of Ring sizers to choose proper size of Ring.

Basically a ring-sizer is a plastic sheet with various sizes mentioned on it , something you can slide off your finger into it to identify an appropriate fit. It is available with all jewelers for sizing your perfect rings so that you can make sure its comfortable while you wear it.

Its fitting should not only be close enough so that it stays on, but slack enough to slide off at the finger.

2. See your finger size at the end of the day and when your fingers are fairly warm.

It happens that the size of your finger changes very precisely, based on the time of the day, what you've been doing, and the kind of weather. Fingers are smaller in the early morning and when cold.Do measure your finger a few times at different times of day, to be sure you get a perfect sizing for your rings.Never use strings or sizing tape to try to measure your finger size. This may be very inaccurate, and lead to ill-fitting rings.

3. Find your size.

The below sizes are the width of your finger. Sometimes even after using the ring-sizer, you are confused between two sizes in that case always use a size bigger . This will ensure that you have some extra room and your ring will fit perfectly . The most common women's size is 6, while the most common men's size is 9.
Size 5 – 15.7mm
Size 6 – 16.5mm
Size 7 – 17.3mm
Size 8 – 18.2mm
Size 9 – 18.9mm
Size 10 – 19.8mm
Size 11 – 20.6mm
Size 12 – 21.3mm
Size 13 – 22.2mm

4. Consider getting your ring resized if it doesn't fit.

§ Tension rings: Gemstone in tension settings aren't mounted in prong but they're holded in place by a perfect pressure. Tension rings need to be order-made also. If you try to resize it, the circular strength that holds the diamond in place is disturbed and damaged.

§ Eternity bands: Eternity or infinite rings have a circle of small cover stones all around the ring. These rings are made on orders and almost impossible to resize. If you try to resize it it will break the perfect flow of the stone.

§ Stainless steel, tungsten, or titanium rings: These metals can’t be resized because they're too hard to mould it . Usually , men's wedding band are made of these metals, so when you order one, make sure you know your accurate size.

Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *